Motorsports Village
http://motorsportsvillage.com/forum/

slow progress but its slowly happenin.
http://motorsportsvillage.com/forum/viewtopic.php?f=9&t=7495
Page 1 of 1

Author:  phoenix1 [ Sat Jul 31, 2010 5:13 am ]
Post subject:  slow progress but its slowly happenin.

Hi all, a couple of pics of my slow build. Its torana coupe with 598 talldeck and glide. Engine made around 980 asp here in Australia (sold as 1030 in the us ) and we have set up to take a fourhundred shot as well . car weighs arpond 3100lb . Image

Author:  phoenix1 [ Sat Jul 31, 2010 5:15 am ]
Post subject:  Re: slow progress but its slowly happenin.

ImageImage

Author:  phoenix1 [ Sat Jul 31, 2010 5:18 am ]
Post subject:  Re: slow progress but its slowly happenin.

ImageImageImage

Author:  phoenix1 [ Sat Jul 31, 2010 5:22 am ]
Post subject:  Re: slow progress but its slowly happenin.

our other one with a small block . ImageImage

Author:  Beretta [ Sat Jul 31, 2010 7:03 am ]
Post subject:  Re: slow progress but its slowly happenin.

That should open your eyes when you hit the gas O:) O:) ...That looks like a Vega sort of I guess #-o ...What is in it for a rear/cage/trans/ Tell us more or did I miss that????

Nice job though \:D/ \:D/ \:D/

Author:  us7race [ Sat Jul 31, 2010 1:09 pm ]
Post subject:  Re: slow progress but its slowly happenin.

Looks like you pay alot of attention to detail. Really nice car. Very Clean looking. good Job let us know what it runs.. Any idea when you will get it to the track with the new Bullet?

Author:  phoenix1 [ Sat Jul 31, 2010 5:48 pm ]
Post subject:  Re: slow progress but its slowly happenin.

Beretta wrote:
That should open your eyes when you hit the gas O:) O:) ...That looks like a Vega sort of I guess #-o ...What is in it for a rear/cage/trans/ Tell us more or did I miss that????
Image
Nice job though \:D/ \:D/ \:D/

The trans is a deadenbear case glide with 1.8 gear set , roller tail etc. the converter is a mechanical diode made here in australia and should give me around 5500 rpm. the rear end at this stage is a modified factory rear which is a bit like a four link. there are some of these casrs running 7.70 on 11.5 and the same rear end here . I am going to try radials i think however i have some slicks as well. i am at the moment trying to get some weight out of the car with glass bits and alluminium brackets etc. the cage is a ten point moly cage ,Imagethe pipes and ignition are the ones we used on the dyno . i am using a digi 7 , and edelb rock controller for the gas .ImageImage

Author:  phoenix1 [ Sat Jul 31, 2010 5:53 pm ]
Post subject:  Re: slow progress but its slowly happenin.

Image the fabricator sayin nooooooo

Page 1 of 1 All times are UTC - 5 hours
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/