Motorsports Village
http://motorsportsvillage.com/forum/

flex plate to converter spacers
http://motorsportsvillage.com/forum/viewtopic.php?f=8&t=9240
Page 1 of 1

Author:  Larry Woodfin [ Wed May 30, 2012 8:49 pm ]
Post subject:  flex plate to converter spacers

I just know someone like Grainger, Fastenal or McMaster Carr stocks bulk spacers but time spent web checking has not found them.

I need 1/4" thick X 7/16" ID. Anyone have suggestions? Other sources?

Author:  Ken0069 [ Wed May 30, 2012 9:01 pm ]
Post subject:  Re: flex plate to converter spacers

Mine were made at a local machine shop out of one inch round cold rolled steel that was drilled and parted off on a lathe. Ya just have to make sure they're all the same thickness.

"Back In The Day" I used a stack of flat washers where needed. Sometimes ya just have to improvise!

Author:  inVEGArating [ Mon Jun 04, 2012 5:03 pm ]
Post subject:  Re: flex plate to converter spacers

i believe jegs has a kit with three of 1/8",3/16" and 1/4" that are parallel ground and cadium plated

Author:  inVEGArating [ Mon Jun 04, 2012 5:12 pm ]
Post subject:  Re: flex plate to converter spacers

sorry for the double post,i looked in the shop and i have three 1/4' thick 7/16" i.d. converter shims,if you need them pm me your address and i will mail them to you

Page 1 of 1 All times are UTC - 5 hours
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/