|crane vs msd, low hp turbov8
|Page 1 of 1|
|Author:||holdenguy [ Sat Feb 02, 2013 4:09 am ]|
|Post subject:||crane vs msd, low hp turbov8|
Im looking for an ignition for a street/strip turbov8 blowthrough deal, its a holdenv8 (for the aussies here) that im pretty confidant will see about 600hp from 350 cubes, not a monster engine by any stretch but im parts limited on this deal (poor old block has had a hard life and i didnt want to spend too much on a 0.040" over 2 bolt early casting) and its about 150 more than i had before.
Im looking at a 6530 or the hi-6 with retard, id like the ignition to be good enough for a better engine later (maybe 800 or so)
What do you guys think?
|Author:||Ken0069 [ Sat Feb 02, 2013 6:43 am ]|
|Post subject:||Re: crane vs msd, low hp turbov8|
According to shrinker, that HI-6 is about as good as you can get and much better than anything MSD currently sells.
|Page 1 of 1||All times are UTC - 5 hours|
|Powered by phpBB® Forum Software © phpBB Group|