Motorsports Village
http://motorsportsvillage.com/forum/

Rubber gaskets
http://motorsportsvillage.com/forum/viewtopic.php?f=21&t=9793
Page 1 of 1

Author:  F636 [ Tue Dec 11, 2012 3:53 am ]
Post subject:  Rubber gaskets

I meant to post this question a while ago but of course other things had my attention, quicker ET! I noticed after a couple of months using E85 that my rubber felpro valve cover gaskets are basicly disintigrating. I had no issue using race gas and when I went to check valve lash the gaskets fell apart! My rubber oil pan end seals don't seam to have this issue. Has anyone else noticed this and if so, what material are you using?
Thanks, Keith

Author:  Beretta [ Tue Dec 11, 2012 5:55 am ]
Post subject:  Re: Rubber gaskets

I am not having any issues here with them....Mine are the blue rubber with the steel inside..Guessing your using the same ones??

Author:  F636 [ Tue Dec 11, 2012 3:52 pm ]
Post subject:  Re: Rubber gaskets

Thanks Barry, No I'm using the plain black rubber felpro's. I was wondering if the blue ones like your using were that much different in material. I'll get a set along with the pan gasket just to be sure. Thanks.

Author:  mslayton [ Tue Dec 11, 2012 4:26 pm ]
Post subject:  Re: Rubber gaskets

I'm running the blue felpro's on both valve covers and oil pan gaskets and haven't noticed any issues.

Page 1 of 1 All times are UTC - 5 hours
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/